load cell hardware

It depends on the anchor type and expected load. Typically, a center-hole load cell with a capacity 20–30% above the maximum test load works well. You’ll also need a bearing plate and a spherical seating to correct for slight misalignments. Kingmach provides matched setups that include the cell, cabling, and calibration certificates—just specify your tendon diameter and test load range.

Most likely yes. Our standard output is mV/V, which is industry-wide. If your logger accepts 4–20 mA, RS-485, or 0–5 V, we can integrate a signal conditioner inside the load cell or in an inline enclosure. Just share the input specs of your logger, and we’ll match the output.

We machine the loading surfaces flat and parallel, and we offer spherical seating rings for compression cells. For center-hole designs, the load introduction surfaces are hardened to prevent brinelling from the anchor wedge. These steps minimize eccentricity effects, but if you expect severe misalignment, we can discuss a custom load button or double-membrane design.

Standard modifications—like a non-standard capacity or cable length—usually take 2–3 weeks. Fully custom dimensions or special materials can take 4–6 weeks, depending on complexity. We keep semi-finished components in stock to shorten the wait for urgent projects. Contact us early with your specs, and we’ll give you a realistic schedule.